Super Power 2 PCB and Panel

Please note: This includes the PCB only; you will need to source the rest of the parts. Please see the link to the BOM below.

Synthrotek’s Super Power 2 gives you loads of power and is skiffable at just 46mm deep! Designed with safety in mind, Super Power has reverse polarity protection and converters with short circuit, overheating, and over current protection.

The Super Power 2 now gives you the ability to set your power voltages precisely to +12V and -12V, which is critical for 1 v/o applications, oscillator tuning, and dialing in voltages between systems. On any power supply, your power voltages will change slightly as modules are added or removed from your system; now you can adjust your voltages quickly and easily with two trimmers accessible from the front panel. Add in the TS2 and you can quickly and easily plug your multimeter or oscilloscope in to check your voltages!

Features:

• Multiple power options to fit your needs and budget:
• RED: Power one row of 104HP.*
• GREEN: Power two rows of 104HP.*
• BLUE: Power three to four rows of 104HP.*

• Advanced low-noise, fully-regulated voltage converters on each rail
• Trimmers for dialing in precise power voltages, accessible from the front panel
• Over-current protection: shuts off each power rail automatically if modules use too much current on that rail
• Two 16-Pin Eurorack power connectors, keyed for safety
• Molex quick-release connector for easy install of Synthrotek Noise Filtering Distribution Boards
• USB jack for powering an iPhone, Beat Step Pro, etc.
• Input Voltage Range: 16 to 19 volts DC
• Requires 16-19V power brick, DC Input Jack size: 2.1mm
• Module Width: 4HP
• Module Depth: 46mm